3 Metre Brush Strip Draught Excluder 3 piece Kit With 15 mm Brush

A 3 PART KIT ie  3 lengths  x 1000 mm 

(cutting tolerance is +0.00/-5.00 mm ie parts supplier 995 -1000 mm)

GAP SIZE 0 – 12 MM

THIS UK MADE PRODUCT IS USED BY THE DOOR REPAIR INDUSTRY

THIS PRODUCT (SUBJECT TO SIZING (BELOW) WILL FIT DOWN THE BOTTOM OF AN UP AND OVER GARAGE DOOR) WITH THIS KIT IT WILL SEAL FROM 2000 MM UP TO 2985 MM, (6 TO 9 FEET 9.50 “)

IF YOU NEED OTHER SIZES PLEASE ASK, OTHER TRIMS ON OUR CULLEY_FAMILY_SHOP

This correctly made brush strip is not an import; this is made in the UK with pride

We make a full fill brush with the right components. This is our 4 mm series backing width brush

Our brushes are made of nylon 6 an important factor we feel.

The carrier is made from architectural aluminium a point worth noting, it makes the carrier stronger, its overall height of the flat part of the h holder is 16 mm, the trim of brush is 15 mm out of the steel backing inside the aluminium on this sizing giving about 13 mm of bristle out of the aluminium holder.

We supply this part in 3 off pieces @ 1000 mm long so the item can be sent by myhermes courier to any UK postcode.

for the technically minded , nylon 6 is a harder wearing material against concrete than polypropylene Nylon 6 has a higher working temperature of about 145 degrees centigrade

Polypropylene softens at 70 – 80 degrees centigrade. A temperature your garage door reaches when it gets warm in the summer , polypropylene bristles then bend and stays bent causing the brush to appear to move away from its opposing surface, I will leave you to decide which is the right choice , I will say chalk and cheese!  

(A lot of competitors use this and also partial fill! to make brushes lower in cost for them!)

The brush strip should only be fitted to the outside of an up and over door , as the rear of the door dips slightly upon lifting , if you put a brush or any seal on the bottom ,it will catch and scrap causing the door to judder on opening , a problem if you have motor driven doors.

Also fitting our brush strip on the outside gives a further important benefit; you are not creating a dirt and insect trap in front of the door to blow in when the door is lifted.

This item is suitable for draught proofing , dust  sealing , dust sealing , insect sealing , stops flies , stops moths , cock roaches yes they are in the UK, ,aluminium,timber ,steel , PVCu, GRP  doors,

We have developed the seal to go up the sides of an up and over door as well look on our shop

Cuts easily with top hardened cutters, or good pincers and junior hacksaw,comes with full fitting instructions, you need to follow the full instructions 

WE DO NOT SUPPLY SCREWS AS WE KNOW DIFFERENTSURFACES REQUIRE DIFFERENT FIXINGS AND DIFFERENT COLOURS, AGAIN WE DO NOT DRILLTHE PRODUCT AS ALL THE HOLES WILL NOT LINE UP WITH YOUR DOOR.

Culley’s also stock a large range of other style draught excluders, brush strips & weather strip products and also trade rubber extrusions.

Please enquire. Via e bay questions for help sealing other stylesof windows or doors; we solve 95% of problems with draught invasion! Ourproduct offers money saving where heating takes place.

DON’T HEAT THE STREET, SAVE IT!!! ITS YOUR MONEY