Garage door draught excluder brush strip kit in 4 pieces up to 4000 mm wide/15mm

draught proof now before winter

KEEP THE MICE OUT 

THIS IS A 4 PART KIT OF 4 X 1000 MM 

GAP SIZE 0 – 12 MM

THIS UK MADE PRODUCT IS USED BY THE DOOR REPAIR INDUSTRY

THIS PRODUCT (SUBJECT TO SIZING (BELOW) WILL FIT DOWN THE BOTTOM OF AN UP AND OVER GARAGE DOOR) WITH THIS KIT IT WILL SEAL FROM 3.00 METRES UP TO 4.00 METRES ,  ( 9 FEET 10 INCHES   TO 13 FEET 1 “ wide )

IF YOU NEED OTHER SIZES PLEASE ASK, OTHER TRIMS ON OUR CULLEY_FAMILY_SHOP

This correctly made brush strip is not an import; this is made in the UK with pride

We make a full fill brush with the right components. This is our 4 mm series backing width brush

Our brushes are made of nylon 6 an important factor we feel.

The carrier is made from architectural aluminium a point worth noting, it makes the carrier stronger, its overall height of the flat part of the h holder is 16 mm, the trim of brush is 15 mm out of the steel backing inside the aluminium on this sizing giving about 13 mm of bristle out of the aluminium holder.

We supply this part in 4  off pieces @ 1000 mm long so the item can be COURIERED to MOST UK postcode.

ISLANDS AND OBSCURE PLACE , NORTHERN SCOTLAND , PLEASE ASK FOR RATE 

for the technically minded , nylon 6 is a harder wearing material against concrete than polypropylene Nylon 6 has a higher working temperature of about 145 degrees centigrade

We do not use Polypropylene but competitors do , it softens at 70 – 80 degrees centigrade. A temperature your garage door reaches when it gets warm in the summer , polypropylene bristles then bend and stays bent causing the brush to appear to move away from its opposing surface, I will leave you to decide which is the right choice , I will say chalk and cheese!  

(A lot of competitors use this and also partial fill! to make brushes lower in cost for them!)

The brush strip should only be fitted to the outside of an up and over door , as the rear of the door dips slightly upon lifting , if you put a brush or any seal on the bottom ,it will catch and scrap causing the door to judder on opening , a problem if you have motor driven doors.

This item is suitable for draught proofing , dust  sealing , dust sealing , insect sealing , stops flies , stops moths , cockroaches yes they are in the UK, ,aluminium,t imber ,steel , PVCu, GRP  doors,

Cuts easily with top hardened cutters, or good pincers and junior hacksaw, comes with full fitting instructions, you need to follow the full instructions 

WE DO NOT SUPPLY SCREWS AS WE KNOW DIFFERENT SURFACES REQUIRE DIFFERENT FIXINGS AND DIFFERENT COLOURS, AGAIN WE DO NOT DRILLTHE PRODUCT AS ALL THE HOLES WILL NOT LINE UP WITH YOUR DOOR.

We have also developed and have on sale "thehairyworm" seal to go up the sides of an up and over door ,please look on our shop

Culley’s also stock a large range of other style draught excluders, brush strips & weather strip products and also trade rubber extrusions.

Please enquire. Via e bay questions for help sealing other styles of windows or doors; we solve 95% of problems with draught invasion! Our product offers money saving where heating takes place.

DON’T HEAT THE STREET, SAVE IT!!! ITS YOUR MONEY