Quality 2 off 914mm dark brown PVCU door draught excluder, 22mm nylon brush strip.

2 x dark brown PVCU carriers.

Long life dense full fill brush.

2 lengths at 914 mm, (36 inches) with slotted holes dark brown PVCU brush strip to high quality in dark brown.

Not available in the shops.

For gap sizes 0 – 20 mm.

This premier door bottom brush (subject to sizing (below) will fit down the bottom of doors with a flat floor underneath with this it will seal up to 914 mm, (3 feet) in length

Easy to cut to size.

If you need other sizes of any draught excluder please ask, ring 0161 622 0020 for free advice on other trims.

This correctly made brush strip is not an import; this is made in the UK with pride and used by the door repair industry.

We make a full fill brush with the right components. This is our 4 mm series backing width brush.

Our brushes are made of nylon 6 an important factor we feel.

The carrier is made from PVCU not ordinary plastic its overall height of the flat part of the h holder is 18 mm, the trim of brush is 22 mm out of the steel backing inside the aluminium on this sizing giving about 20 mm of bristle out of the holder.

We supply this part only to UK mainland.

For the technically minded, nylon 6 is a harder wearing material against concrete than polypropylene nylon 6 has a higher working temperature of about 145 degrees centigrade
Polypropylene softens at 70 – 80 degrees centigrade. A temperature your garage door reaches when it gets warm in the summer , polypropylene bristles then bend and stays bent causing the brush to appear to move away from its opposing surface, I will leave you to decide which is the right choice, I will say chalk and cheese!
(A lot of competitors use this and also partial fill! To make brushes lower in cost for them!)

This item is suitable for draught proofing, dust sealing, dust sealing, insect sealing, stops flies, stops moths, cock roaches yes they are in the UK, aluminium, timber, steel, PVCU, group doors.

Cuts easily with top hardened cutters, or good pincers and junior hacksaw, comes with full fitting instructions, you need to follow the full instructions.

We do not supply screws as we know different surfaces require different fixings and different colours, this item is hole punched with elongated holes every 150 mm approx.
This is random starts , due to the way it is done during extrusion, being a continuous process of up down / up down the saw cuts being at 914 mm, it does vary through a large run !

This is thehairyworm product made by the Culley family; we also stock a large range of other style draught excluders, brush strips & weather strip products and also trade rubber extrusions.

Please enquire for help sealing other styles of windows or doors; we solve 95% of problems with draught invasion! Our product offers money saving where heating takes place.

Don’t heat the street, save it! It’s your money.