Two brushes for french double doors. 850mm long each, with 22mm trim height. Covers 1.7m total.

A 2 part kit for double French split doors for up to 1.70 metres wide, (other sizes made to order).

Each piece of strip is 0.85 metres, if you require other sizes please ask we can cut whatever you want!

Gap size 0 – 20 mm.

This correctly made brush strip is not an import; this is made in the UK with pride and used by the door repair industry.

We make a full fill brush with the right components. This is our 4 mm series backing width brush.

Our brushes are made of nylon 6 an important factor we feel.

The carrier is made from architectural aluminium a point worth noting, it makes the carrier stronger, its overall height of the flat part of the h holder is 16 mm, the trim of brush is 22 mm out of the steel backing inside the aluminium on this sizing giving about 20 mm of bristle out of the aluminium holder.

We supply this part in 2 pieces 850 mm long, that’s each @ 2 foot 9.46 inches
(so the item can be couriered to most UK postcode. Not channel islands).

For the technically minded, nylon 6 is a harder wearing material against concrete than polypropylene nylon 6 has a higher working temperature of about 145 degrees centigrade
Polypropylene softens at 70 – 80 degrees centigrade. A temperature your garage door reaches when it gets warm in the summer , polypropylene bristles then bend and stays bent causing the brush to appear to move away from its opposing surface, I will leave you to decide which is the right choice , I will say chalk and cheese!
(a lot of competitors use this and also partial fill! To make brushes lower in cost for them!)

Architectural aluminium a point worth noting, it makes the carrier stronger, its overall height of the flat part of the h holder is 16 mm, the trim of brush is 15 mm out of the steel backing inside the aluminium on this sizing giving about 13 mm of bristle out of the aluminium holder.

The brush strip should only be fitted to the outside of an up and over door , as the rear of the door dips slightly upon lifting , if you put a brush or any seal on the bottom ,it will catch and scrape causing the door to judder on opening , a problem if you have motor driven doors.
Also fitting our brush strip on the outside gives a further important benefit; you are not creating a dirt and insect trap in front of the door to blow in when the door is lifted.

This item is suitable for draught proofing, dust sealing, dust sealing , insect sealing , stops flies, stops moths, cock roaches yes they are in the UK, aluminium, timber, steel, PVCU, grp doors, etc.

We have also developed the seal to go up the sides of an up and over door as well look on our shop.

Cuts easily with top hardened cutters, or good pincers and junior hacksaw, comes with full fitting instructions, you need to follow the full instructions.

We do not supply screws as we know different surfaces require different fixings and different colours, again we do not drill the product as all the holes will not line up with your door.

Culley’s also stock a large range of other style draught excluders, brush strips & weather strip products and also trade rubber extrusions.

Please enquire for help sealing other styles of windows or doors; we solve 95% of problems with draught invasion! Our product offers money saving where heating takes place.
Don’t heat the street, save it!!! It’s your money.